The range 73-74bit is nearly done, there will be a cleanup of the rest of open reserved tests. The runtime started from 1h23min at 128-131M (@RX5500 XT) and decreasing for higher ranges.

How many percent (%) through the range are we?
Run time is now 2 minutes 32 seconds on a 3080

How many percent (%) through the range are we?
Run time is now 2 minutes 32 seconds on a 3080

https://www.mersenne.ca/status/tf/0/0/1/10000

Check the 74 column.

Thanks. It says there is a total of 10946308 I am unsure what the starting number was. The 400M column under 74 says 1608935
From the above number is it possible to tell roughly when we are going to go to a higher range?

How many percent (%) through the range are we?
Run time is now 2 minutes 32 seconds on a 3080

https://www.mersenne.ca/status/tf/0/0/1/10000

Check the 74 column.

Thanks. It says there is a total of 10946308 I am unsure what the starting number was. The 400M column under 74 says 1608935
From the above number is it possible to tell roughly when we are going to go to a higher range?

10M are the total available tests to process. We are getting faster and faster the higher the range. Perhaps one year left to finish.

Nice, so from here on in work will only get faster or will work unit eventually increase again when we go to a lower range? If we are going to go to a high range is there a way for us to tell by looking at work unit names/numbers when the change will happen